As an Amazon Associate I earn from qualifying purchases.1. Aroidful
Aroidful 220-240V Inline LED Dimmer Switch 3-100W, Trailing Edge Dimmer Rotary ON/OFF LED Dimmer for Dimmable LED Lights/Incandescent/Halogen, LED Dimmable Switch for Living Room Bedroom Hotel RV
Aroidful - With overload, in line with UKCA/CE/ROHS safety standards. Easy installation: led dimmer connected by screw terminals, built-in knob switch and knob dimming control, soldering terminals without soldering iron, equipped with terminals, easy to install.
Wide application: this 3-100w led dimmer switch is suitable for dimmable LED desk lamps, high voltage halogen lamps, incandescent lamps, high voltage LED strips, low voltage halogen lamps with electronic transformers, LED floor lamps, etc.
Voltage: 220-240V AC. Attention: inline dimmer switch it cannot be used for speed control of fans and motors, nor for inductive loads!!! The applicable power: The incandescent lamps/halogen lamps: 3-100W.
Dimmable led ligths PF=Power factor: PF>09: 3…100w; pf>05: 3…50w. Product specification: trailing edge dimmer dimming range is 0-100%, and the dimming process completely silent and noise-free. Premium quality: led dimmable switch made of high-quality flame-retardant material, over-current, over-temperature protection, the internal high-quality circuit board is safe, reliable and durable.
2. ElekTek
ElekTek in Line Rotary Dimmer Switch Rated 20-160w 240v AC 3 Core Suitable for Incandescent Lamps and Bulbs Black
ElekTek - Please note: not suitable for led bulbs, 12v dc low voltage lighting or tranSFORMERS. For use with 2 or 3 core flexes - earth terminal is present.
Check your bulbs before ordering suitable for all 240v ac incandescent/halogen filament bulbs. Rated for lamps 20-160 watts 220-240v ac, 50/60 hz - not suitABLE FOR LED BULBS.
Minimum load is 20 watts - loads lower than this will cause malfunction. -. Maximum load is 160 watts - loads greater than this will cause malfunction. Not suitable for led bulbs. With illuminated wheel and internal fuse. Not suitable for leds, 12v dc lighting or TRANSFORMERS.
| Brand | ElekTek |
| Manufacturer | ElekTek |
| Height | 2.8 cm (1.1 Inches) |
| Length | 9.6 cm (3.78 Inches) |
| Width | 3.05 cm (1.2 Inches) |
| Part Number | 1004 |
3. VIPMOON
Built-in Rotary ON/OFF and Knob Control Dimmer for Dimmable 3-100W LED/Incandescent/Halogen Bulbs, VIPMOON Inline LED Dimmer Switch
VIPMOON - Premium quality: excellent quality with overload protection, over current protection, over temperature protection and corresponds to the CE and ROHS safety standards. Technical advantage: 220~240vac 3-100w inline trailing edge phase-cut dimmer, the dimming process is completely silent and will not make a buzzing sound! The lowest brightness can be preset, and the dimming range is 0-100%.
Energy savings: works with max 50 watts of dimmable led bulbs or 100 Watts of Incandescent/Halogen Bulbs, Dimming range 0 — 100% to cut energy costs and extend bulb life.
Scope of application: suitable for any dimmable led/incandescent/halogen transformer.
It cannot be used for speed control of induction transformers, fans and motors. Eyes protection: dim the lights 0% - 100% to let your eyes gradually adapt to bright light or darkness; reduce eyestrain and protect your eyes from overly bright lights. Led lights not less than 3w, LED lights must be dimmable and must be compatible with trailing edge dimmers.
| Brand | VIPMOON |
| Manufacturer | VIPMOON |
| Height | 3.48 cm (1.37 Inches) |
| Length | 8.1 cm (3.19 Inches) |
| Width | 3.34 cm (1.31 Inches) |
| Part Number | 1 |
4. ElekTek
ElekTek LED Compatible Universal in Line Foot Dimmer Switch 240v AC 3 Core Suitable for Quality LED CFL & Incandescent Bulbs Black
ElekTek - Please note: not suitable for 12v lighting or transformers. Includes complete fitting instructions. Rated for quality dimmable led lamps between a total output of 8-24 watts MAXIMUM 4 BULBS. For use with 2 or 3 core flex 075mm2 max - size: 100mm diameter 29mm high plus controls 100-240v AC, 50/60 Hz ONLY.
Dimming capability of certain bulbs can be dependent on the quality of manufacture, always use a recognised brand of dimmable bulbs. Lamp can be switched off at favourite setting using the on/off button. Rated for incandescent lamps between a total output of 8-250 watts.
| Brand | ElekTek |
| Manufacturer | ElekTek |
| Height | 3.65 cm (1.44 Inches) |
| Length | 10 cm (3.94 Inches) |
| Width | 10 cm (3.94 Inches) |
| Part Number | 1012 |
5. greenandco
With Push Buttons for Continuous Brightness Control, White, 2X greenandco® gc-50 Digital LED in-line Cord Dimmer Switch, 1-50 Watt
greenandco - Features: designed for table lamps, floor lamps and any lamps having a cable connected to the main electrical power supply; user friendly maximum and minimum tuning; overheat, overload and short circuit protection; easy installation replacing existing switches or simply at any point of a connecting cable; on/off indicator lamp.
Included components: greenandco gc-50 leD in-line cord dimmer, comprehensible English instructions, cable not included! Product safety: we attach great importance to the safety of our products.
Greenandco products meet all relevant national and European standards and are tested by independent institutes such as TÜV.
Upon request, we will send you the certificates and test reports. Range of use: suitable for 230 v halogen bulbs, incandescent bulbs, dimmable LED bulbs from 1-50 VA and dimmable electronic transformers. Warning notice: Electronic equipment must be installed by an authorised electrician. Do not use the lED dimmer for flourescent lighting, fans or toroids.
6. ElekTek
ElekTek LED Compatible Universal in Line Push Button Dimmer Switch 240v AC 2 Core Suitable for LED CFL & Incandescent Bulbs Gold Effect
ElekTek - Includes complete fitting instructions - Before installing, switch off electricity at mains. A universal dimmer - rated for dimmable led lamps between a total output of 4-25 watts - MAXIMUM 4 BULBS.
Rated for dimmable cfl lamps between a total output of 11-25 watts - MAXIMUM 4 BULBS. Rated for standard incandescent lamps between a total output of 10-150 watts - 50/60 Hz - For use with 2 core flexes max 075 square mm.
Please note: not suitable for 12v lighting or transformers. Dimming capability of certain bulbs can be dependent on the quality of manufacture, always use a recognised brand of dimmable bulbs.
| Brand | ElekTek |
| Height | 2.8 cm (1.1 Inches) |
| Length | 9.6 cm (3.78 Inches) |
| Width | 3.05 cm (1.2 Inches) |
| Part Number | 1004P |
| Model | 1004P |
7. sourcing map
Sourcing map LED Strip Dimmer Switch 12-24V DC PWM Rotary Inline Dimmer Controller with DC Jack Cord for LED Strips Lights, Pack of 4, Black
sourcing map - Connect the load line first, and the brightness gradually becomes brighter, then the power line please ensure there is no short circuit between the connecting lines before powering on; 2.
Knob operation controls 0% - 100% dimming, avoiding visual impact on eyes caused by instantaneous changes in brightness. The led strip dimmer switch provides here is: output current:
8. Zeifun
Pendant Lights, Inline DImmer Switch for Dimmable LED, Incandescent Bulbs, Inline Cord Switch Replacement for Table Lamp, White Rotary Dimmer, Halogen, Dimmable Lamp Switch 2 Pack, Bedroom
Zeifun - Smooth surface without burrs, allowing anyone to change the lighting smoothly. With latest dimming technology, you could customize dimming range to a certain percentage by simple steps. Please rest assured to purchase. Led compatible dimmerthe lamp switch replacement fits well with up to 25W dimmable LED or 80W incandescent / halogen bulbs.
Then fitting the wires into the terminals and tighten screws. Advanced dimming functioninline dimmer switch allows you to adjust the light from 0%-100% brightness.
Perfect for reading, watching movies or enjoying romantic dinners. You just need cut the wires on where you want to install the switch. High-end materialrotary dimmer switch features premium plastic shell, durable for years of use.
Great diy accessories for repairing or refurbishing damaged lighting switch. These inline cord switches are easy to install. Choosing any type of bulbs for various occasions. Simple installation stepsall necessary screws and user manual are included in package. High efficient customer servicewe guarantee to always provide the best quality product and 24 months warranty, covering any manufacturing defects discovered in this time period.
| Brand | Zeifun |
| Manufacturer | Zeifun |
| Part Number | White-Switch |
| Model | White-Switch |
9. URPIZY
URPIZY Inline LED Dimmer Switch, Built-in Rotary ON/OFF and Knob Control Dimmer for Dimmable 10-60W LED/Incandescent/Halogen Bulbs Black
URPIZY - Has been confirmed to work with LED lights. Fire prevention PC case. Phase failure at the trailing edge, equipped with wiring terminals, built-in rotary on/off and knob dimming control, no need for neutral.
Easy to use. If the wiring cable is relatively thick, the N-line terminal does not need to be wired, and it is directly connected to the lamp, only the L wires at both ends need to be connected. Dimmable incandescent:10-60W. The specifications must indicate the LED lights are dimmable.
10. sourcing map
Black White, Pack of 2, sourcing map LED Strip Light Dimmer Switch 12-24V DC PWM Rotary Inline Dimmer Controller with DC Connector for LED Strips Lights
sourcing map - The led strip dimmer switch is a knob-operated control. Operate the other way around, and turn to the far right, the light goes out. The led strip dimmer switch provides here is: output current:
Aroidful - With overload, in line with UKCA/CE/ROHS safety standards. Easy installation: led dimmer connected by screw terminals, built-in knob switch and knob dimming control, soldering terminals without soldering iron, equipped with terminals, easy to install.
ElekTek - Please note: not suitable for led bulbs, 12v dc low voltage lighting or tranSFORMERS. For use with 2 or 3 core flexes - earth terminal is present.
VIPMOON - Premium quality: excellent quality with overload protection, over current protection, over temperature protection and corresponds to the CE and ROHS safety standards. Technical advantage: 220~240vac 3-100w inline trailing edge phase-cut dimmer, the dimming process is completely silent and will not make a buzzing sound! The lowest brightness can be preset, and the dimming range is 0-100%.
ElekTek - Please note: not suitable for 12v lighting or transformers. Includes complete fitting instructions. Rated for quality dimmable led lamps between a total output of 8-24 watts MAXIMUM 4 BULBS. For use with 2 or 3 core flex 075mm2 max - size: 100mm diameter 29mm high plus controls 100-240v AC, 50/60 Hz ONLY. Dimming capability of certain bulbs can be dependent on the quality of manufacture, always use a recognised brand of dimmable bulbs. Lamp can be switched off at favourite setting using the on/off button. Rated for incandescent lamps between a total output of 8-250 watts.
greenandco - Features: designed for table lamps, floor lamps and any lamps having a cable connected to the main electrical power supply; user friendly maximum and minimum tuning; overheat, overload and short circuit protection; easy installation replacing existing switches or simply at any point of a connecting cable; on/off indicator lamp.
ElekTek - Includes complete fitting instructions - Before installing, switch off electricity at mains. A universal dimmer - rated for dimmable led lamps between a total output of 4-25 watts - MAXIMUM 4 BULBS.
sourcing map - Connect the load line first, and the brightness gradually becomes brighter, then the power line please ensure there is no short circuit between the connecting lines before powering on; 2. Knob operation controls 0% - 100% dimming, avoiding visual impact on eyes caused by instantaneous changes in brightness. The led strip dimmer switch provides here is: output current: 
Zeifun - Smooth surface without burrs, allowing anyone to change the lighting smoothly. With latest dimming technology, you could customize dimming range to a certain percentage by simple steps. Please rest assured to purchase. Led compatible dimmerthe lamp switch replacement fits well with up to 25W dimmable LED or 80W incandescent / halogen bulbs.
URPIZY - Has been confirmed to work with LED lights. Fire prevention PC case. Phase failure at the trailing edge, equipped with wiring terminals, built-in rotary on/off and knob dimming control, no need for neutral. Easy to use. If the wiring cable is relatively thick, the N-line terminal does not need to be wired, and it is directly connected to the lamp, only the L wires at both ends need to be connected. Dimmable incandescent:10-60W. The specifications must indicate the LED lights are dimmable.
